Hayes Microcomputer Products Mwave Manual de usuario

Linux ACP Modem (Mwave) mini−HOWTOMike [email protected] [email protected] Yokley − Edited document and coverted to DocBook

IRQ 4, I/O address 0x3f8 (if using ttyS0)For dual boot systems we recommeded that you use the Thinkpad" Config

setserial /dev/ttySxThe above command should return the following for serial port 1:/dev/ttyS1, UART: 16550A, Port: 0x2f8, IRQ: 3The port and IRQ numb

4. Debugging Tips4.1. Error LogsErrors encountered by the ACP Modem device driver or application are logged using the syslog utility.4.2. TracingThe

MWMPW32_TRACE=1MWMUTIL_TRACE=1MWWTT32_TRACE=1Trace information is logged using the syslog utility.Linux ACP Modem (Mwave) mini−HOWTO4. Debugging Tips

5. Test ClaimsThis driver has been tested using the ThinkPad" 600E. The same chipset is integrated on the 600 and 770models and should work.5. T

6. List of Supported CountriesThe following countries are supported by the ACP Modem driverTable 1. List of Supported CountriesCountry Name CountryAcc

EL_SALVADOR 503FINLAND 358FRANCE 33GERMANY 49GREECE 30GRENADA 111GUATEMALA 502GUYANA 592HONDURAS 504HONG_KONG 852HUNGARY 36INDIA 91INDONESIA 62IRELAND

PHILIPPINES 63POLAND 48PORTUGAL 351PRC 852ROMANIA 40RUSSIA 7SAUDI_ARABIA 966SINGAPORE 65SLOVAKIA 421SLOVENIA 386SOUTH_AFRICA 27SPAIN 34ST_KITTS_NEVIS

7. TrademarksHayes is a trademark of Hayes Microcomputer Products, Inc.MNP (Microcom Network Protocol) is a trademark of Microcom, Inc.IBM is a tradem

Table of Contents1. General Information and Hardware Requirements...1

1. General Information and HardwareRequirements1.1. IntroductionThe ACP Modem for Linux is a software based modem. Support software for the ACP modem

1.6. Which Systems are SupportedThis version of the ACP Modem driver supports the IBM Thinkpad" 600E, 600, and 770 that includeon−board ACP mode

2. Compilation, Installation, and Startup2.1. PrerequisitesA 2.2.16 series (or later) Linux kernel source tree • An appropriate set of module utilitie

Country information (including access codes) are listed in the mwavem.conf file. For example, for Francethe following section is present:[Telephony\C

The following arguments are not persistent from boot toboot (i.e. We are not saving them in the BIOS).mwave_3780i_irq=5/7/10/11/15 • This parameter a

during the build process.Setup the serial driver to recognize the UART provided by the ACP driver. 2. setserial /dev/ttyS0 autoconfigNOTESubstitute /

3. Resolving Installation and ConfigurationProblemsThe following sections list solutions to possible problems you may experience.3.1. DSP Does Not Sta